How To Fix QP398 - Only relative tolerances can be defined as depending on a target value

QP398 - Overview

• Message type: E = Error

• Message class: QP - Message IDs for function module group QPAA

• Message number: 398

• Message text: Only relative tolerances can be defined as depending on a target value

What causes this issue?

You want to define target value-dependent tolerances.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Set the indicator for relative tolerances.

Error message extract from SAP system. Copyright SAP SE.

QP398 - Details

• The SAP error message QP398, which states "Only relative tolerances can be defined as depending on a target value," typically occurs in the context of quality management (QM) when you are trying to set up tolerances for inspection characteristics in a quality inspection plan.
  
  Cause:
  This error arises when you attempt to define absolute tolerances (fixed values) that are dependent on a target value. In SAP QM, only relative tolerances (which are expressed as a percentage of the target value) can be set to depend on a target value. This means that if you want to use a target value to determine tolerances, those tolerances must be defined as relative.
  
  Solution:
  To resolve this error, you should:
  
  
  Check Tolerance Settings: Go to the inspection characteristic settings in your quality inspection plan and verify the type of tolerances you have defined.
  
  
  Change to Relative Tolerances: If you have defined absolute tolerances, change them to relative tolerances. This