How To Fix QE379 - Share was estimated for the sample

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 379

• Message text: Share was estimated for the sample

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE379 - Share was estimated for the sample ?

  The SAP error message QE379, which states "Share was estimated for the sample," typically occurs in the context of quality management and sampling procedures within SAP. This message indicates that the system has estimated the share of a particular characteristic for a sample rather than calculating it based on actual measurements. This can happen for various reasons, including:
  Causes:
  
  Insufficient Data: The system may not have enough actual measurement data for the characteristic in question, leading it to estimate the share.
  Sampling Procedure: The sampling procedure defined in the quality management settings may be set to estimate shares when certain conditions are not met.
  Configuration Issues: There may be configuration settings in the quality management module that are not aligned with the expected behavior for sampling and share calculations.
  Quality Inspection Lot: The quality inspection lot may not have been fully processed or may be in a status that does not allow for actual measurements to be taken.
  
  Solutions:
  
  Check Measurement Data: Ensure that there are actual measurement results recorded for the characteristic in question. If not, perform the necessary measurements.
  Review Sampling Procedure: Examine the sampling procedure settings in the quality management configuration to ensure they are set up correctly and allow for actual measurements.
  Inspect Quality Inspection Lot: Verify the status of the quality inspection lot. If it is incomplete or in a status that does not allow for measurements, complete the necessary steps to finalize it.
  Configuration Review: Consult with your SAP configuration team to review the settings related to quality management and sampling to ensure they are correctly configured.
  Documentation and Help: Refer to SAP documentation or help resources for more detailed information on the specific configuration and settings related to quality management and sampling.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide guidance on configuration settings.
  Quality Management Module: Familiarize yourself with the Quality Management (QM) module in SAP, particularly the aspects related to sampling and inspection lot processing.
  User Forums and Communities: Engage with SAP user communities or forums where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or your organization's SAP support team for further assistance.