How To Fix PPH_DD183 - Product &1 Plant &2 MRP Area &3 is repeated in longest path

SAP Error Message - Details

• Message type: E = Error

• Message class: PPH_DD - Messages for Demand Driven

• Message number: 183

• Message text: Product &1 Plant &2 MRP Area &3 is repeated in longest path

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPH_DD183 - Product &1 Plant &2 MRP Area &3 is repeated in longest path ?

  The SAP error message PPH_DD183 indicates that there is a problem with the configuration of the Material Requirements Planning (MRP) area in the system. Specifically, it suggests that the same product is being referenced multiple times in the longest path of the MRP area, which can lead to circular dependencies or infinite loops in the planning process.
  Cause:
  
  Duplicate Entries: The same product is assigned to the same MRP area multiple times, which can happen due to incorrect configuration or data entry.
  Circular Dependencies: The MRP area may have been set up in such a way that it creates a circular reference, causing the planning logic to fail.
  Incorrect MRP Area Configuration: The MRP area may not be configured correctly, leading to conflicts in the planning process.
  
  Solution:
  
  
  Check MRP Area Configuration:
  
  Go to the MRP area configuration in SAP and verify that the product is not assigned multiple times to the same MRP area.
  Ensure that the MRP area is set up correctly without any circular references.
  
  
  
  Review Product Assignment:
  
  Check the assignment of the product to the MRP area. Make sure that each product is only assigned once to each MRP area.
  If duplicates are found, remove the unnecessary entries.
  
  
  
  Analyze Planning Parameters:
  
  Review the planning parameters for the product and MRP area to ensure they are set correctly and do not conflict with each other.
  
  
  
  Run MRP Again:
  
  After making the necessary corrections, run the MRP process again to see if the error persists.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for more detailed guidance on MRP area configuration and troubleshooting.
  
  
  
  Related Information:
  
  MRP Areas: MRP areas are used in SAP to define specific areas for planning materials, allowing for more granular control over inventory and production planning.
  Circular Reference: A circular reference occurs when a product or process refers back to itself, which can create logical inconsistencies in planning.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or support team for further assistance.