How To Fix PHIN110 - Unit of measurement for measuring point characteristic & not defined

SAP Error Message - Details

• Message type: E = Error

• Message class: PHIN - Phase In: Messages

• Message number: 110

• Message text: Unit of measurement for measuring point characteristic & not defined

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PHIN110 - Unit of measurement for measuring point characteristic & not defined ?

  The SAP error message PHIN110 indicates that there is an issue with the unit of measurement (UoM) for a measuring point characteristic that has not been defined in the system. This error typically arises in the context of Plant Maintenance (PM) or Environmental, Health, and Safety (EHS) modules where measuring points are used to record measurements.
  Cause:
  
  Missing Unit of Measurement: The specific measuring point characteristic does not have an associated unit of measurement defined in the system.
  Configuration Issues: The configuration settings for the measuring point or characteristic may not be properly set up.
  Data Entry Errors: There may be a mistake in the data entry where the unit of measurement was not specified or was incorrectly entered.
  
  Solution:
  
  
  Define Unit of Measurement:
  
  Go to the transaction code CUNI (Unit of Measure) in SAP.
  Check if the unit of measurement for the specific measuring point characteristic is defined.
  If it is not defined, create a new entry for the unit of measurement.
  
  
  
  Check Measuring Point Configuration:
  
  Use transaction code IK01 (Create Measuring Point) or IK02 (Change Measuring Point) to review the configuration of the measuring point.
  Ensure that the measuring point characteristic is correctly linked to a defined unit of measurement.
  
  
  
  Review Characteristic Settings:
  
  Go to transaction code CT04 (Create Characteristic) and check the settings for the characteristic in question.
  Ensure that the unit of measurement is assigned to the characteristic.
  
  
  
  Data Validation:
  
  Validate the data entries for the measuring point to ensure that all required fields, including the unit of measurement, are filled out correctly.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on configuring measuring points and characteristics.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  CUNI: Manage Units of Measure
  IK01/IK02: Create/Change Measuring Point
  CT04: Create Characteristic
  
  
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to measuring points and units of measurement.
  User Roles: Ensure that the user has the necessary permissions to make changes to the configuration settings.
  
  By following these steps, you should be able to resolve the PHIN110 error and ensure that the unit of measurement for the measuring point characteristic is properly defined.