How To Fix O3280 - AGA8:Error code 12: Flowing pressure (material pressure) is out of range

SAP Error Message - Details

• Message type: E = Error

• Message class: O3 - IS-Oil: HPM messages (goods movements, QCI, deliveries)

• Message number: 280

• Message text: AGA8:Error code 12: Flowing pressure (material pressure) is out of range

What causes this issue?

The flowing pressure is not within the valid range for the AGA c-code.

System Response

The QCI (Quantity Conversion Interface) stops processing.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Enter a pressure value in the correct range.
The valid range is, according to the AGA c-code documentation:
0 < P / PSIA < 1740 ,
or
0 < P / MPa < 12 .

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message O3280 - AGA8:Error code 12: Flowing pressure (material pressure) is out of range ?

  The SAP error message O3280 AGA8: Error code 12: "Flowing pressure (material pressure) is out of range" typically occurs in the context of process control or production planning within SAP, particularly in modules related to manufacturing or logistics. This error indicates that the pressure values being monitored or calculated for a specific material or process are outside the acceptable range defined in the system.
  Causes:
  
  Incorrect Configuration: The pressure limits for the material may not be correctly configured in the system.
  Faulty Sensors: If the pressure sensors or measuring devices are malfunctioning, they may report incorrect values.
  Process Variability: Variations in the production process or material properties can lead to unexpected pressure readings.
  Data Entry Errors: Manual entry of pressure values or parameters may have been done incorrectly.
  System Bugs: There may be bugs or issues in the SAP system that lead to incorrect calculations or readings.
  
  Solutions:
  
  Check Configuration: Review the configuration settings for the material in question. Ensure that the pressure limits are set correctly in the material master or relevant configuration tables.
  Inspect Sensors: Verify the functionality of the pressure sensors. If they are faulty, they may need to be recalibrated or replaced.
  Review Process Parameters: Analyze the production process to identify any variations that could be causing the pressure to exceed the defined limits. Adjust the process parameters as necessary.
  Correct Data Entry: If the error is due to incorrect manual entries, correct the data in the system and ensure that proper validation checks are in place to prevent future errors.
  Consult Documentation: Refer to SAP documentation or support resources for specific guidance related to the error code and context.
  Contact SAP Support: If the issue persists and cannot be resolved through the above steps, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide patches or updates.
  User Forums: Engage with SAP user communities or forums where similar issues may have been discussed.
  Training: Ensure that users involved in the process are adequately trained on how to handle pressure-related parameters and understand the implications of the error.
  
  By following these steps, you should be able to diagnose and resolve the issue related to the SAP error message O3280 AGA8.