How To Fix O3233 - QCI: No unit with a dimension ID "dimensionless" was found

SAP Error Message - Details

• Message type: E = Error

• Message class: O3 - IS-Oil: HPM messages (goods movements, QCI, deliveries)

• Message number: 233

• Message text: QCI: No unit with a dimension ID "dimensionless" was found

What causes this issue?

The system tried to retrieve one unit of measure with the
"dimensionless" dimension, but not one unit has been maintained in
table T006. The Quantity Conversion Interface (QCI) requires this
information to check the correctness of the unit of measure that you
input.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Maintain at least one UoM with the "dimensionless" dimension.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message O3233 - QCI: No unit with a dimension ID "dimensionless" was found ?

  The SAP error message O3233, which states "QCI: No unit with a dimension ID 'dimensionless' was found," typically occurs in the context of Quality Management (QM) or when dealing with characteristics in SAP that require specific units of measure. This error indicates that the system is unable to find a unit of measure that corresponds to the specified dimension ID, which in this case is "dimensionless."
  Cause:
  
  Missing Unit of Measure: The most common cause of this error is that there is no unit of measure defined in the system for the dimension ID "dimensionless." This can happen if the unit of measure has not been created or has been deleted.
  Configuration Issues: There may be issues in the configuration of the characteristics or the quality inspection plans that reference this dimension.
  Data Inconsistencies: There could be inconsistencies in the data where the characteristic is expected to have a unit of measure but is not properly linked to one.
  
  Solution:
  
  
  Check Unit of Measure Configuration:
  
  Go to the transaction code CUNI (Maintain Units of Measure) in SAP.
  Verify if there is a unit of measure defined for "dimensionless." If not, you may need to create it.
  Ensure that the unit of measure is correctly configured and active.
  
  
  
  Review Characteristics and Inspection Plans:
  
  Check the characteristics that are being used in the quality inspection plan. Ensure that they are correctly defined and linked to the appropriate units of measure.
  Use transaction code QS22 to review and modify the inspection plans if necessary.
  
  
  
  Create or Modify Characteristics:
  
  If the characteristic is supposed to be dimensionless, ensure that it is set up correctly in the characteristic definition. You can do this using transaction code CT04 (Create Characteristic).
  Make sure that the characteristic does not require a unit of measure if it is truly dimensionless.
  
  
  
  Consult Documentation: If you are unsure about the configuration or the expected behavior, refer to SAP documentation or consult with your SAP QM functional consultant for guidance.
  
  
  Testing: After making the necessary changes, perform a test to ensure that the error no longer occurs and that the quality inspection process works as expected.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  Training and Documentation: Ensure that users involved in the configuration and use of QM processes are adequately trained and have access to the necessary documentation.
  
  By following these steps, you should be able to resolve the O3233 error and ensure that your quality management processes function correctly.