How To Fix MD06035 - Function not possible; destination MRP area &1 is type &2

MD06035 - Overview

• Message type: E = Error

• Message class: MD06 - MRP Area

• Message number: 035

• Message text: Function not possible; destination MRP area &1 is type &2

What causes this issue?

The destination MRP area &v1& is type &v2& and is therefore a plant MRP
area and thus cannot be created.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

MD06035 - Details

• The SAP error message MD06035 indicates that there is an issue with the MRP (Material Requirements Planning) area in your system. Specifically, the message states that a function is not possible for the specified MRP area because of its type. 
  
  Cause:
  The error typically arises due to one of the following reasons:
  
  Incorrect MRP Area Type: The MRP area you are trying to use is of a type that does not support the operation you are attempting. For example, certain functions may only be applicable to specific types of MRP areas (e.g., plant-specific, storage location-specific).
  
  Configuration Issues: There may be a configuration issue in the MRP area settings, where the type of MRP area is not aligned with the intended use.
  Data Integrity Issues: There could be inconsistencies or missing data related to the MRP area in the master data.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check MRP Area Type:
  
  Go to the