How To Fix L6078 - Stor.type & not allowed for accum.trans. (select again)

L6078 - Overview

• Message type: E = Error

• Message class: L6 - LVS Link R/2 - ECC

• Message number: 078

• Message text: Stor.type & not allowed for accum.trans. (select again)

What causes this issue?

You selected the transaction for the cumulative transmission of
differences. For this transaction, you selected a storage type that is
intended specifically for inventory differences.

System Response

The transaction was interrupted.

How to fix this error?

Start the transaction again with the correct storage type or select
another transaction.
&FURTHER_HINTS&
For further information about the cumulative transmission of differences
from the ERP System to the R/2 System, refer to the <LS>MM Warehouse
Management Guide</>.

Error message extract from SAP system. Copyright SAP SE.

L6078 - Details

• The SAP error message L6078 indicates that the storage type specified is not allowed for accumulation transactions. This typically occurs in the context of warehouse management (WM) or inventory management (IM) when trying to perform operations that involve accumulating stock in a storage type that is not configured to allow such transactions.
  
  Cause:
  
  Storage Type Configuration: The storage type you are trying to use for the accumulation transaction is not set up to allow accumulation. This could be due to the storage type being configured for specific types of operations (e.g., picking, putaway) but not for accumulation.
  Transaction Type Restrictions: Certain transaction types may have restrictions on which storage types can be used. If the transaction you are trying to perform is not compatible with the storage type, this error will occur.
  Warehouse Management Settings: The overall settings in the warehouse management module may not permit accumulation in the specified storage type.
  
  
  Solution:
  
  
  Check Storage Type