How To Fix IS192 - Stock control active (profile &3) for material &1 in plant &2

SAP Error Message - Details

• Message type: E = Error

• Message class: IS - Equipment management

• Message number: 192

• Message text: Stock control active (profile &3) for material &1 in plant &2

What causes this issue?

The serial number profile &V3& is assigned to material &V2& in plant
&V1&. You have set checks for this profile in the event of changes to
the stock information in Customizing.

System Response

You can set two system reactions in Customizing:
If an error occurs, changes cannot be made to either the stock
information or the material number.
If a warning occurs, you should check the desired change once again.
After confirming the notification, you can perform the desired change
if necessary.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message IS192 - Stock control active (profile &3) for material &1 in plant &2 ?

  The SAP error message IS192 indicates that stock control is active for a specific material in a particular plant, and it is associated with a specific profile. This error typically arises when you attempt to perform an operation that is not allowed due to the stock control settings for that material.
  
  Cause:
  
  Stock Control Activation: The material in question has stock control activated, which means that certain operations (like goods movements, inventory management, etc.) are restricted or require specific conditions to be met.
  Material Master Settings: The material master record may have settings that enforce stock control, such as the valuation type or stock type.
  Profile Settings: The profile mentioned in the error message may have specific configurations that enforce stock control for the material.
  
  
  Solution:
  
  
  Check Material Master: 
  
  Go to the material master record (transaction code MM03) and check the settings for the material in the relevant plant. Look for stock control settings under the