How To Fix IR141 - Several measuring points with measurement position &

IR141 - Overview

• Message type: E = Error

• Message class: IR - PM: IMRC - Measurement Readings and Counters

• Message number: 141

• Message text: Several measuring points with measurement position &

What causes this issue?

You have tried to identify a <GL:measuring_point>measuring point</>
using the field <LS>Measurement position</>. There are, however,
several measuring points for which the field Measurement position has
the content &V1&.

System Response

The system could not determine a unique measuring point.

How to fix this error?

Make sure that for measuring points that you want to determine using the
Measurement position field, that this field content is also unique in
your system. The system can support you in doing this if you use a
<GL:measuring_point_category>measuring point category</>, that is set
accordingly in <GL:Customizing>Customizing</>.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message IR141 - Several measuring points with measurement position & ?

  The SAP error message IR141, which states "Several measuring points with measurement position &," typically occurs in the context of asset management or plant maintenance when there are multiple measuring points associated with a single measurement position. This can lead to confusion or conflicts in data entry or reporting.
  
  Cause:
  
  Multiple Measuring Points: The primary cause of this error is that there are multiple measuring points defined for the same measurement position in the system. This can happen due to incorrect configuration or data entry.
  Data Duplication: It may also occur if there are duplicate entries in the measuring points for a specific measurement position.
  
  Configuration Issues: Incorrect configuration in the measuring point setup can lead to this error.
  
  
  Solution:
  
  Review Measuring Points: Check the measuring points associated with the measurement position in question. You can do this by navigating to the relevant transaction (e.g., IL03 for measuring points) and reviewing the entries.
  Consolidate or Remove Duplicates: