How To Fix GPD2007 - Inconsistency in PEG_TXPT: Mat: &1,Sender Repobj: &2, Receiver Repobj: &3

SAP Error Message - Details

• Message type: E = Error

• Message class: GPD2 - GPD for DIMP4.71 uses message class GPD & GPD2

• Message number: 007

• Message text: Inconsistency in PEG_TXPT: Mat: &1,Sender Repobj: &2, Receiver Repobj: &3

What causes this issue?

Pegging found inconsistency in the in-transit pegging table ( PEG_TXPT
).

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check data in table PEG_TXPT.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPD2007 - Inconsistency in PEG_TXPT: Mat: &1,Sender Repobj: &2, Receiver Repobj: &3 ?

  The SAP error message GPD2007 indicates an inconsistency in the PEG_TXPT table, which is related to the Product and Process Management (PPM) module in SAP. This error typically arises when there are discrepancies in the data related to the sender and receiver representative objects (Repobj) for a material.
  Cause:
  The error can be caused by several factors, including:
  
  Data Inconsistency: There may be inconsistencies in the data stored in the PEG_TXPT table, such as missing or incorrect entries for the specified material and representative objects.
  Configuration Issues: Incorrect configuration settings in the system related to the product or process management.
  Master Data Issues: Problems with the master data of the material, such as missing or incorrect information in the material master or related tables.
  Transport Issues: If changes were transported from one system to another, inconsistencies may arise if the transport did not include all necessary objects.
  
  Solution:
  To resolve the GPD2007 error, you can follow these steps:
  
  
  Check Data Consistency:
  
  Use transaction codes like SE16 or SE11 to view the PEG_TXPT table and check for inconsistencies related to the specified material and representative objects.
  Look for any missing entries or discrepancies in the data.
  
  
  
  Review Configuration:
  
  Verify the configuration settings in the PPM module to ensure they are set up correctly.
  Check if the sender and receiver representative objects are correctly defined and linked to the material.
  
  
  
  Correct Master Data:
  
  Review the material master data for the specified material and ensure that all required fields are filled out correctly.
  Make any necessary corrections to the master data.
  
  
  
  Transport Check:
  
  If the issue arose after a transport, check the transport logs to ensure that all necessary objects were included in the transport.
  If needed, re-transport the missing objects or manually correct the inconsistencies.
  
  
  
  Consult SAP Notes:
  
  Search for relevant SAP Notes in the SAP Support Portal that may address this specific error message or provide additional guidance.
  
  
  
  Contact SAP Support:
  
  If the issue persists after performing the above steps, consider reaching out to SAP Support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: SE16 (Data Browser), SE11 (Data Dictionary), and possibly others related to PPM.
  SAP Notes: Always check for any specific SAP Notes related to GPD2007 for updates or patches that may resolve the issue.
  Documentation: Review SAP documentation related to Product and Process Management for best practices and troubleshooting tips.
  
  By following these steps, you should be able to identify and resolve the inconsistency causing the GPD2007 error in your SAP system.