How To Fix FTR_TCORF_MSG015 - Configuration table not defined for node '&1'

FTR_TCORF_MSG015 - Overview

• Message type: E = Error

• Message class: FTR_TCORF_MSG - Correspondence Messaging Interface: Messages

• Message number: 015

• Message text: Configuration table not defined for node '&1'

What causes this issue?

The configuration node '&V1&' has no assigned table. This configuration
node has different attributes depending on a value from the parent
level. These attributes are stored in different tables. This means that
the system should display different tables according to the selected
parent entry. In this case, there is no defined table for the selected
line of the parent level.

System Response

No table can be displayed. Navigation to the node is aborted.

How to fix this error?

It is possible that the given configuration node should not have any
attribute and that is why it is correct, as there is no table defined
for it. In this case, you have nothing to do. The configuration is
correct and you have no attribute here to maintain.
If there are attributes in this configuration node for the selected
parent entry, then the setting for this table is missing. Corresponding
customizing table is TCORFC_CONFIG. You can find more information there.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FTR_TCORF_MSG015 - Configuration table not defined for node '&1' ?

  The SAP error message FTR_TCORF_MSG015 indicates that a configuration table is not defined for a specific node in the system. This error typically arises in the context of Financial Transaction Management (FTM) or related modules where certain configuration settings are required for processing transactions.
  
  Cause:
  
  Missing Configuration: The most common cause of this error is that the necessary configuration for the specified node (indicated by &1) has not been set up in the system.
  Incorrect Node Reference: The node referenced may not exist or may have been incorrectly specified in the configuration.
  Transport Issues: If the configuration was recently transported from another system, it may not have been properly imported or activated.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access the configuration settings.
  
  
  Solution:
  
  
  Check Configuration:
  
  Navigate to the relevant configuration area in SAP (usually under the Financial Transaction Management settings).
  Verify that the configuration for the specified node exists and is correctly defined.
  If