How To Fix FTI345 - No NPV type found for position management procedure &1

SAP Error Message - Details

• Message type: E = Error

• Message class: FTI - Treasury Information System

• Message number: 345

• Message text: No NPV type found for position management procedure &1

What causes this issue?

No NPV type was found for the position management procedure displayed.
Define an NPV type in Customizing.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FTI345 - No NPV type found for position management procedure &1 ?

  The SAP error message FTI345 "No NPV type found for position management procedure &1" typically occurs in the context of Financial Transaction Management (FTI) when the system is unable to find a Net Present Value (NPV) type associated with a specific position management procedure. This can happen for various reasons, including configuration issues or missing data.
  Cause:
  
  Missing Configuration: The NPV type may not be configured for the specified position management procedure in the system.
  Incorrect Procedure Assignment: The position management procedure might not be correctly assigned or might not exist in the system.
  Data Inconsistency: There could be inconsistencies in the data related to the position management procedure or NPV types.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access the required configuration.
  
  Solution:
  
  
  Check Configuration:
  
  Go to the configuration settings for Financial Transaction Management.
  Verify that the NPV type is defined for the position management procedure in question.
  If it is missing, you will need to create or assign the appropriate NPV type.
  
  
  
  Review Position Management Procedure:
  
  Ensure that the position management procedure (&1) is correctly defined and active in the system.
  Check if the procedure is correctly linked to the relevant NPV types.
  
  
  
  Data Consistency Check:
  
  Run consistency checks to ensure that all related data is correctly set up and there are no discrepancies.
  You may need to consult with your SAP Basis or technical team to perform deeper checks.
  
  
  
  User Authorizations:
  
  Ensure that the user encountering the error has the necessary authorizations to access the configuration and data related to NPV types and position management procedures.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on configuring NPV types and position management procedures.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (for configuration) or other relevant transaction codes to check the settings.
  SAP Notes: Look for SAP Notes related to FTI345 for any known issues or patches that may address this error.
  Community Forums: Check SAP Community forums or other user groups for similar issues and solutions shared by other users.
  
  By following these steps, you should be able to identify and resolve the cause of the FTI345 error in your SAP system.