How To Fix FRMLMSC130 - No density has been specified for stream &1

SAP Error Message - Details

• Message type: E = Error

• Message class: FRMLMSC - RMS-FRM: Miscellaneous Messages for Formula

• Message number: 130

• Message text: No density has been specified for stream &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FRMLMSC130 - No density has been specified for stream &1 ?

  The SAP error message FRMLMSC130, which states "No density has been specified for stream &1," typically occurs in the context of process engineering or material management within SAP, particularly when dealing with streams in a process or material flow.
  Cause:
  This error indicates that the system is expecting a density value for a specific stream (denoted by &1), but none has been provided. Density is a critical parameter in many calculations, especially in chemical processes, as it affects the mass flow rate and other related calculations.
  Solution:
  To resolve this error, you need to specify a density for the stream in question. Here are the steps you can take:
  
  
  Check Stream Configuration:
  
  Navigate to the configuration settings for the stream that is causing the error.
  Ensure that the density is defined in the relevant material master or process configuration.
  
  
  
  Update Material Master:
  
  If the stream is associated with a material, go to the material master record.
  Check the relevant views (like Basic Data, Plant Data, etc.) to see if the density is specified.
  If not, enter the appropriate density value.
  
  
  
  Review Process Parameters:
  
  If the error occurs in a process simulation or calculation, review the parameters set for the process.
  Ensure that all necessary parameters, including density, are correctly defined.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on how to set density values for streams in your version of SAP.
  
  
  
  Contact Support:
  
  If you are unable to resolve the issue, consider reaching out to your SAP support team or consulting with an SAP expert who can provide more tailored assistance.
  
  
  
  Related Information:
  
  Transaction Codes: Depending on your SAP version, you may need to use specific transaction codes to access material master data or process configuration.
  SAP Notes: Check for any relevant SAP Notes that might address this error or provide additional context.
  User Roles: Ensure that you have the necessary permissions to make changes to material master data or process configurations.
  
  By following these steps, you should be able to resolve the FRMLMSC130 error and ensure that the necessary density information is provided for the specified stream.