How To Fix FM441 - There are no parameters for dunning run &1 &2

SAP Error Message - Details

• Message type: E = Error

• Message class: FM - Dunning Notices

• Message number: 441

• Message text: There are no parameters for dunning run &1 &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FM441 - There are no parameters for dunning run &1 &2 ?

  The SAP error message FM441 "There are no parameters for dunning run &1 &2" typically occurs when you attempt to execute a dunning run in the SAP system, but the system cannot find the necessary parameters for the specified dunning run. This can happen for several reasons, and here are some common causes, solutions, and related information:
  Causes:
  
  Missing Dunning Parameters: The dunning run you are trying to execute does not have any parameters defined in the system.
  Incorrect Dunning Run Configuration: The dunning run may not be properly configured in the system, leading to the absence of parameters.
  Dunning Area Not Defined: The dunning area for the specified dunning run might not be defined or activated.
  Authorization Issues: The user executing the dunning run may not have the necessary authorizations to access the dunning parameters.
  
  Solutions:
  
  
  Check Dunning Run Configuration:
  
  Go to the transaction code OBD2 (Dunning Configuration) and verify that the dunning run is correctly configured.
  Ensure that the dunning parameters are defined for the dunning run you are trying to execute.
  
  
  
  Define Dunning Parameters:
  
  If the parameters are missing, you may need to define them. This can be done in the dunning configuration settings.
  Ensure that the dunning procedure, dunning levels, and other related settings are correctly set up.
  
  
  
  Review Dunning Areas:
  
  Check if the dunning area is defined and active. You can do this in the dunning configuration settings.
  Make sure that the dunning area is assigned to the relevant company code.
  
  
  
  User Authorizations:
  
  Verify that the user has the necessary authorizations to execute the dunning run. This can be checked with your SAP security team.
  
  
  
  Check for Customizations:
  
  If your organization has custom developments or enhancements related to dunning, ensure that they are functioning correctly and not causing the issue.
  
  
  
  Related Information:
  
  Transaction Codes: 
  
  F150: Execute Dunning Run
  OBD2: Dunning Configuration
  OBD3: Dunning Procedure
  
  
  SAP Notes: Check for any relevant SAP Notes that might address known issues or bugs related to dunning runs.
  Documentation: Refer to the SAP Help Portal for detailed documentation on dunning processes and configurations.
  
  If the issue persists after checking the above points, it may be beneficial to consult with your SAP support team or reach out to SAP support for further assistance.