How To Fix FCOM_PLANNING_CORE202 - Wrong unit for statistical key figure &1 entered (&2 should be &3)

FCOM_PLANNING_CORE202 - Overview

• Message type: E = Error

• Message class: FCOM_PLANNING_CORE - Messages for Package FCOM_PLANNING_CORE

• Message number: 202

• Message text: Wrong unit for statistical key figure &1 entered (&2 should be &3)

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FCOM_PLANNING_CORE202 - Wrong unit for statistical key figure &1 entered (&2 should be &3) ?

  The SAP error message FCOM_PLANNING_CORE202 indicates that there is a mismatch in the units used for a statistical key figure in a planning scenario. Specifically, the error message states that the unit entered for the statistical key figure is incorrect, and it provides the expected unit and the unit that was entered.
  
  Cause:
  This error typically occurs when:
  
  The statistical key figure is defined with a specific unit in the system, and the value being entered does not match that unit.
  There may be a configuration issue where the unit of measure for the statistical key figure is not correctly set up in the planning layout or master data.
  The user may have mistakenly entered a value in the wrong unit (e.g., entering a value in kilograms when the system expects grams).
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Unit of Measure:
  
  Verify the unit of measure for the statistical key figure in