How To Fix EL610 - Dev. &1, reg. &2: Result cannot be estimated without previous result

SAP Error Message - Details

• Message type: E = Error

• Message class: EL - IS-U meter reading data processing

• Message number: 610

• Message text: Dev. &1, reg. &2: Result cannot be estimated without previous result

What causes this issue?

The result &v3& cannot be re-estimated because no previous result was
found.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the meter reading results.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EL610 - Dev. &1, reg. &2: Result cannot be estimated without previous result ?

  The SAP error message EL610 indicates that there is an issue with the estimation of a result in a development environment. This error typically occurs in the context of SAP's logistics or production planning modules, where certain calculations or estimations depend on prior results or data.
  Cause:
  The error message "Result cannot be estimated without previous result" suggests that the system is trying to perform a calculation or estimation that requires prior data or results that are either missing or have not been calculated yet. This can happen due to several reasons, including:
  
  Missing Data: The necessary previous results or data entries have not been created or are missing.
  Incorrect Sequence of Operations: The operations or processes are not being executed in the correct order, leading to a lack of prerequisite results.
  Configuration Issues: There may be configuration settings in the system that are not set up correctly, preventing the system from accessing the required data.
  Data Integrity Issues: There may be inconsistencies or errors in the data that prevent the system from retrieving the necessary previous results.
  
  Solution:
  To resolve the EL610 error, you can take the following steps:
  
  
  Check Previous Results: Verify if the required previous results or data entries exist. If they do not, ensure that the necessary processes have been completed to generate them.
  
  
  Review Process Flow: Ensure that the operations are being executed in the correct sequence. If a prerequisite step has been skipped, complete that step before attempting to estimate the result again.
  
  
  Data Validation: Check for any data integrity issues. Ensure that all relevant data is accurate and complete. You may need to run data consistency checks or validations.
  
  
  Configuration Review: Review the configuration settings related to the module you are working with. Ensure that all necessary settings are correctly configured to allow for the estimation process.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance related to the module you are working with. There may be additional troubleshooting steps or considerations specific to your scenario.
  
  
  Contact Support: If the issue persists after checking the above points, consider reaching out to SAP support or your internal IT support team for further assistance.
  
  
  Related Information:
  
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message. SAP frequently updates its knowledge base with solutions to common problems.
  Transaction Codes: Familiarize yourself with relevant transaction codes that may help in troubleshooting, such as those for data validation or process monitoring.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the root cause of the EL610 error and implement a solution to resolve it.