How To Fix EL232 - &1 Device &2, MR date &3 estimated or read by customer more than &4 times

SAP Error Message - Details

• Message type: E = Error

• Message class: EL - IS-U meter reading data processing

• Message number: 232

• Message text: &1 Device &2, MR date &3 estimated or read by customer more than &4 times

What causes this issue?

The permitted number of customer meter readings or estimations was
exceeded during validation <LS>04</>. You define the permitted number
in the <LS>Meter reading control</> in the installation.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

The meter reading can either be released or deferred for processing at
a later date.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EL232 - &1 Device &2, MR date &3 estimated or read by customer more than &4 times ?

  The SAP error message EL232 indicates that a specific device (meter) has had its reading or estimated reading processed more than a specified number of times within a defined period. This is typically related to the management of meter readings in the SAP IS-U (Industry Solution for Utilities) module.
  Cause:
  The error message EL232 is triggered when:
  
  A meter reading (MR) for a specific device has been entered or estimated more than the allowed number of times (as defined by the system settings).
  This can happen due to multiple reasons, such as:
  
  Incorrect manual entries by users.
  System errors or bugs that cause repeated processing of the same reading.
  A high frequency of estimated readings due to issues with the physical meter or data collection processes.
  
  
  
  Solution:
  To resolve the EL232 error, consider the following steps:
  
  
  Check the Meter Reading History:
  
  Review the meter reading history for the device in question to identify how many times readings have been entered or estimated.
  
  
  
  Review Configuration Settings:
  
  Check the configuration settings in the SAP system that define the maximum number of times a meter reading can be processed. This can usually be found in the IS-U configuration settings.
  
  
  
  Correct Duplicate Entries:
  
  If there are duplicate entries, correct them by removing or adjusting the unnecessary readings.
  
  
  
  Investigate System Errors:
  
  If the error seems to be caused by a system issue, investigate any recent changes or updates to the system that may have affected the meter reading process.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the EL232 error for any specific guidance or patches that may address the issue.
  
  
  
  Contact SAP Support:
  
  If the issue persists and cannot be resolved through the above steps, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like EL31 (Display Meter Reading) or EL30 (Create Meter Reading) to manage and review meter readings.
  User Exits and BAdIs: Check if there are any user exits or BAdIs that might be affecting the meter reading process.
  Documentation: SAP Help Portal and SAP Notes can provide additional insights and troubleshooting steps for specific error messages.
  
  By following these steps, you should be able to identify the cause of the EL232 error and implement a solution to resolve it.