How To Fix ECATT348 - The test script has been active for &

SAP Error Message - Details

• Message type: E = Error

• Message class: ECATT - eCATT Messages (Middleware and GUI)

• Message number: 348

• Message text: The test script has been active for &

What causes this issue?

When the system prepared the log, the transaction that was started in
eCATT had not been terminated.

System Response

After starting eCATT you can display the log simultaneously in a
different session, even if a transaction is still active.
This message appears only when the time between the start of the
transaction and the log preparation is less than 20 minutes. After 20
minutes the system assumes that the transaction was terminated and
shows the corresponding message.

How to fix this error?

You can repeat the log preparation by selecting "Back" (F3) and
renewing the selection. In this case the system updates the transaction
time or eCATT functions complete the log.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ECATT348 - The test script has been active for & ?

  The SAP error message ECATT348 indicates that a test script in the eCATT (extended Computer Aided Test Tool) framework has been active for a certain period of time, which is specified by the placeholder "&". This message typically arises when a test script is running longer than expected, which can be due to various reasons.
  Causes:
  
  Long Execution Time: The test script may be executing a large number of transactions or complex operations that take longer than usual.
  System Performance Issues: The SAP system may be experiencing performance issues, such as high load or resource contention, causing the script to run slowly.
  Infinite Loops: There may be a logical error in the script, such as an infinite loop or a condition that is never met, causing the script to hang.
  External Dependencies: The script may be waiting for responses from external systems or services that are slow or unresponsive.
  
  Solutions:
  
  Review the Script: Check the logic of the test script for any potential infinite loops or inefficient operations. Optimize the script if necessary.
  Monitor System Performance: Use transaction codes like ST03N or SM66 to monitor system performance and identify any bottlenecks or resource issues.
  Increase Timeout Settings: If the script is expected to take a long time due to legitimate reasons, consider increasing the timeout settings in the eCATT configuration.
  Run in Debug Mode: Execute the script in debug mode to identify where it is taking too long and to troubleshoot any issues.
  Check External Dependencies: If the script interacts with external systems, ensure that those systems are functioning properly and are not causing delays.
  Split the Script: If the script is too large or complex, consider breaking it into smaller, more manageable scripts that can be executed independently.
  
  Related Information:
  
  eCATT Documentation: Refer to the official SAP documentation for eCATT for best practices and guidelines on writing efficient test scripts.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide patches related to eCATT performance.
  Community Forums: Engage with the SAP community forums or support channels for additional insights and solutions from other users who may have encountered similar issues.
  
  By addressing the underlying causes and implementing the suggested solutions, you should be able to resolve the ECATT348 error and improve the performance of your eCATT test scripts.