How To Fix DMEE365 - Error in node &1: incorrect attribute for reference to a technical node

SAP Error Message - Details

• Message type: E = Error

• Message class: DMEE - Messages for Data Medium Exchange Engine

• Message number: 365

• Message text: Error in node &1: incorrect attribute for reference to a technical node

What causes this issue?

Node &V1& contains a reference to technical node &V3& by means of
reference ID &V2&, thereby referencing attribute 1 (contents in output
format). However, in the case of a technical node, the output value is
not filled. For more details, refer to <DS:TX.DMEE_CONVERSION_RULE>Data
Mapping</>.
For this reason, you cannot use this attribute of the technical node.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Change the reference so that the value in the internal format is
referenced.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE365 - Error in node &1: incorrect attribute for reference to a technical node ?

  The SAP error message DMEE365 indicates that there is an issue with the configuration of the Data Medium Exchange Engine (DMEE) in your SAP system. Specifically, it points to an incorrect attribute for a reference to a technical node in the DMEE tree structure.
  Cause:
  The error typically arises due to one of the following reasons:
  
  
  Incorrect Node Configuration: The node in question may not be configured correctly, or it may be referencing attributes that are not valid for the type of node being used.
  
  
  Missing Attributes: The required attributes for the technical node may be missing or incorrectly defined.
  
  
  Hierarchy Issues: The structure of the DMEE tree may not be properly set up, leading to references that do not align with the expected configuration.
  
  
  Version Compatibility: There may be compatibility issues if the DMEE version does not support certain attributes or configurations.
  
  
  Solution:
  To resolve the DMEE365 error, you can follow these steps:
  
  
  Check Node Configuration:
  
  Go to the DMEE tree structure in transaction code OBPM or DMEE.
  Identify the node mentioned in the error message (replace &1 with the actual node name).
  Verify that the attributes for this node are correctly defined and appropriate for the type of node.
  
  
  
  Review Attributes:
  
  Ensure that all required attributes for the technical node are present and correctly configured.
  If you are using a reference to another node, ensure that the referenced node has the correct attributes defined.
  
  
  
  Validate Hierarchy:
  
  Check the overall hierarchy of the DMEE tree to ensure that all nodes are correctly linked and that there are no orphaned nodes or incorrect references.
  
  
  
  Test Configuration:
  
  After making changes, test the configuration by generating the output again to see if the error persists.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific details on the attributes and configuration for the DMEE nodes you are using.
  
  
  
  Seek Support:
  
  If the issue persists after checking the configuration, consider reaching out to SAP support or consulting with a colleague who has experience with DMEE configurations.
  
  
  
  Related Information:
  
  Transaction Codes: Use transaction codes like OBPM (for DMEE tree maintenance) and DMEE (for DMEE configuration) to access the relevant settings.
  SAP Notes: Check for any relevant SAP Notes that might address known issues or provide additional guidance on DMEE configurations.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify and correct the configuration issue causing the DMEE365 error.