How To Fix DGA353 - Data record &1, &2: Packaging code inner packaging &3 does not exist

DGA353 - Overview

• Message type: E = Error

• Message class: DGA - DG: Messages for Dangerous Goods Management (A)

• Message number: 353

• Message text: Data record &1, &2: Packaging code inner packaging &3 does not exist

What causes this issue?

You have started one of the following actions:
Sending a dangerous goods master record from a source system to a target
system (distribution)
Filling a data record in the dangerous goods master in the target system
from specification management (filling)
However, the entry for packaging code &V3& for regulation &V2& does not
exist in the target system.

System Response

The system does not save the data record.

How to fix this error?

In the target system, create the relevant entry in the IMG activity
<DS:SIMG.GGA_200_400_200>Specify Packaging Codes</>.
Start distribution or filling again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DGA353 - Data record &1, &2: Packaging code inner packaging &3 does not exist ?

  The SAP error message DGA353 indicates that there is an issue with the packaging code for a specific data record. This error typically arises when the system is unable to find the specified inner packaging code in the system's master data. Here’s a breakdown of the cause, potential solutions, and related information:
  
  Cause:
  
  Missing Packaging Code: The inner packaging code specified in the data record does not exist in the system. This could be due to data entry errors or missing master data.
  Incorrect Configuration: The packaging configuration may not be set up correctly in the system, leading to discrepancies.
  Data Migration Issues: If data was migrated from another system, there may have been issues with the packaging codes not being transferred correctly.
  
  
  Solution:
  
  
  Check Packaging Codes:
  
  Go to the relevant transaction (e.g., MM03 for material master) and check if the inner packaging code exists.
  If it does not exist, you will need to create it using the