How To Fix CPE308 - Only one default rounding rule permitted

SAP Error Message - Details

• Message type: E = Error

• Message class: CPE - Commodity Pricing Engine

• Message number: 308

• Message text: Only one default rounding rule permitted

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CPE308 - Only one default rounding rule permitted ?

  The SAP error message CPE308 ("Only one default rounding rule permitted") typically occurs in the context of configuring rounding rules in SAP, particularly in the areas of pricing, cost calculation, or financial transactions. This error indicates that there is an attempt to set multiple default rounding rules, which is not allowed.
  Cause:
  
  Multiple Default Rounding Rules: The primary cause of this error is that the system has been configured with more than one default rounding rule for a particular context (e.g., pricing procedure, condition type).
  Configuration Error: It may arise from incorrect configuration in the customizing settings where rounding rules are defined.
  Data Inconsistency: There might be inconsistencies in the data or settings that lead to the system interpreting multiple rules as defaults.
  
  Solution:
  
  
  Check Rounding Rules Configuration:
  
  Navigate to the relevant configuration settings in SAP (usually found in the SPRO transaction).
  Go to the section where rounding rules are defined (e.g., under Financial Accounting or Sales and Distribution).
  Ensure that only one rounding rule is marked as the default for the relevant context.
  
  
  
  Adjust Rounding Rules:
  
  If you find multiple rules set as default, decide which one should be the default and adjust the settings accordingly.
  Remove the default status from the other rounding rules.
  
  
  
  Review Related Customizing Settings:
  
  Check if there are any other related settings that might be causing conflicts.
  Ensure that the rounding rules are correctly assigned to the relevant pricing procedures or condition types.
  
  
  
  Testing:
  
  After making changes, perform tests to ensure that the error does not reoccur and that the rounding behaves as expected.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on rounding rules and their configuration.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (for configuration), SE11 (for data dictionary), or SE80 (for object navigator) to investigate and modify settings.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional context or solutions.
  User Forums: Consider looking at SAP community forums or user groups for discussions related to this error, as other users may have encountered and resolved similar issues.
  
  By following these steps, you should be able to resolve the CPE308 error and ensure that your rounding rules are correctly configured in SAP.