How To Fix CP489 - The unit for standard value &1 in work center op. set &2 taken from oper.

SAP Error Message - Details

• Message type: E = Error

• Message class: CP - Task list messages: Core data

• Message number: 489

• Message text: The unit for standard value &1 in work center op. set &2 taken from oper.

What causes this issue?

Standard value &V1& in work cenetr operation set &V2& hasno unitt.

System Response

The system searches in the work center operation set for the first
operation, whose standard value &v1& has a unit. This unit is then used
for standard value &v1& in the work center operation set.

How to fix this error?

You can prevent this warning being displayed by entering a unit for the
standard value in the work center operation set.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CP489 - The unit for standard value &1 in work center op. set &2 taken from oper. ?

  The SAP error message CP489 indicates that there is an issue with the unit of measure (UoM) for a standard value in a work center operation set. This error typically arises when the system is unable to find a valid unit of measure for the standard value specified in the operation set.
  Cause:
  
  Missing Unit of Measure: The standard value defined in the work center operation set does not have a corresponding unit of measure assigned.
  Incorrect Configuration: The configuration of the work center or operation set may be incorrect, leading to discrepancies in the expected units.
  Data Inconsistency: There may be inconsistencies in the master data related to the work center or the operation set, such as missing or incorrect entries in the relevant tables.
  
  Solution:
  
  
  Check Work Center Configuration:
  
  Navigate to the work center configuration in SAP (Transaction code: CR01 or CR02).
  Verify that the standard values are correctly defined and that a valid unit of measure is assigned to each standard value.
  
  
  
  Review Operation Set:
  
  Check the operation set configuration (Transaction code: CR03).
  Ensure that the standard values in the operation set have the correct units of measure associated with them.
  
  
  
  Update Master Data:
  
  If there are missing or incorrect entries, update the master data for the work center or operation set to include the correct units of measure.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for specific details on how to configure standard values and units of measure in work centers.
  
  
  
  Testing:
  
  After making the necessary changes, test the configuration by attempting to execute the operation again to ensure that the error is resolved.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  CR01: Create Work Center
  CR02: Change Work Center
  CR03: Display Work Center
  
  
  Tables:
  
  Check relevant tables such as CRHD (Work Center Header) and CRCA (Work Center Capacity) for any inconsistencies.
  
  
  SAP Notes: Look for any SAP Notes related to this error message for additional guidance or patches that may address the issue.
  
  If the problem persists after following these steps, it may be beneficial to consult with your SAP support team or refer to SAP community forums for further assistance.