How To Fix AH102 - Value of command &1 (ARCR &2) greater than value in operation mode & (&)

AH102 - Overview

• Message type: E = Error

• Message class: AH - IS-U billing (master data)

• Message number: 102

• Message text: Value of command &1 (ARCR &2) greater than value in operation mode & (&)

What causes this issue?

The values stored for the commands cannot exceed the values for the
operation modes.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

AH102 - Details

• The SAP error message AH102 indicates that there is a discrepancy between the value of a command and the value defined in the operation mode. Specifically, it suggests that the value of the command (in this case, ARCR) is greater than the allowed value in the specified operation mode.
  
  Cause:
  
  Configuration Issue: The command value being used exceeds the maximum limit set in the operation mode configuration.
  Data Entry Error: There may have been an error in data entry where an incorrect or excessively high value was input.
  System Settings: The operation mode settings may not be aligned with the requirements of the command being executed.
  
  
  Solution:
  
  
  Check Operation Mode Settings:
  
  Navigate to the operation mode configuration in SAP.
  Verify the maximum allowed values for the command in question (ARCR).
  Adjust the operation mode settings if necessary to accommodate the command value.
  
  
  
  Review Command Value:
  
  Check the value being passed to the command ARCR.
  Ensure that it is within the acceptable range