How To Fix 6P707 - Please specify only one default value for reqmts class & at the most

SAP Error Message - Details

• Message type: E = Error

• Message class: 6P - Messages for planned independent requirements (Appl.area 60)

• Message number: 707

• Message text: Please specify only one default value for reqmts class & at the most

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message 6P707 - Please specify only one default value for reqmts class & at the most ?

  The SAP error message 6P707 indicates that there is an issue with the configuration of the requirements class in the system. Specifically, it suggests that multiple default values have been specified for the requirements class, which is not allowed. This error typically occurs in the context of material requirements planning (MRP) or production planning.
  Cause:
  The error is caused by the following:
  
  Multiple entries or configurations have been set for the same requirements class in the system.
  The system expects only one default value for the requirements class, but it has detected more than one.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Configuration:
  
  Go to the configuration settings for the requirements class in the SAP system.
  Navigate to the relevant transaction code (e.g., SPRO) and check the settings under the Production Planning or Material Management sections.
  
  
  
  Identify Duplicates:
  
  Look for any duplicate entries for the requirements class. Ensure that there is only one default value specified.
  If you find multiple entries, determine which one is the correct or intended default value.
  
  
  
  Modify Settings:
  
  Remove or deactivate the duplicate entries so that only one default value remains for the requirements class.
  Save the changes and exit the configuration.
  
  
  
  Test the Changes:
  
  After making the changes, test the process that was causing the error to ensure that it has been resolved.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM02 (Change Material), MD01 (MRP Run), or MD02 (MRP for Single Material) to check the material master data and MRP settings.
  Documentation: Refer to SAP documentation or help files for more detailed information on requirements classes and their configuration.
  Support: If the issue persists after following the above steps, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  By ensuring that only one default value is specified for the requirements class, you should be able to resolve the error message 6P707 effectively.