How To Fix 3G329 - Current value & and original value & of parameter & are different

3G329 - Overview

• Message type: E = Error

• Message class: 3G - Payroll: International

• Message number: 329

• Message text: Current value & and original value & of parameter & are different

What causes this issue?

In the selection screen of the report you have specified a run number to
repeat (error clean-up or supplement) a previous run.

System Response

To ensure that you have not inadvertently entered an incorrect run
number, the system checks other parameters of this current run for
consistency with the respective values of the original run. If there
are inconsistencies, the system aborts further processing.

How to fix this error?

Start the report again and enter the displayed original value for the
parameter displayed in this message.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

3G329 - Details

• The SAP error message 3G329 indicates that there is a discrepancy between the current value and the original value of a specific parameter in the system. This typically occurs in the context of configuration settings or system parameters that are expected to remain consistent but have been altered or are out of sync.
  
  Cause:
  
  Parameter Changes: The parameter in question may have been changed after the original value was set, leading to a mismatch.
  Transport Issues: If the parameter was transported from one system to another (e.g., from development to production), the values may not have been correctly synchronized.
  Manual Adjustments: Manual changes made by users or administrators without proper documentation or communication can lead to this error.
  System Upgrades or Patches: Sometimes, system upgrades or patches can alter parameter values, leading to inconsistencies.
  
  
  Solution:
  
  Check Parameter Values: Use transaction code RZ10 or RZ11 to check the current and original values of the parameter in question. Compare