How To Fix CPOC2006 - Selektionsbereich wurde auf &1 Einträge begrenzt (siehe Langtext)

SAP Error Message - Details

• Message type: E = Error

• Message class: CPOC2 - PP-PI-PMA: PI Sheet Messages, SCM Add-On

• Message number: 006

• Message text: Selektionsbereich wurde auf &1 Einträge begrenzt (siehe Langtext)

Was verursacht dieses Problem?

The number of sets of work instructions to be selected has been limited
to &V1& on the initial screen (see <LS>Max. Number of Work Instructions
</> field). This specification has the following effects on the
internally performed selection steps:
RESET N1
Selection of work instructions without consideration of their status.
For technical reasons, the maximum number specified on the initial
screen relates to this step. Step 1 ended when this number was reached.
Fine selection from the number of hits determined in step 1 on the basis
of the status and the time span specified in the case of status New:
In the number of hits determined, no work instructions satisfying the
status requirements were found. The worklist thus remains empty. Due to
the restriction effective in step 1 however, it is possible that not all
work instructions that actually exist have been taken into account.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

RESET N1
Check - and if necessary narrow down - your selection criteria.
In addition, if necessary, increase the number of sets of work
instructions to be selected on the initial screen for the worklist
<LS>Max. Number of Work Instructions</> field).
However, note that increasing the maximum number too much may lead to
performance problems.

Vorgehensweise für Systemadministratoren

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE